There are many ways to deal with common faults of high-frequency equipment. For example, the most common one is high-frequency sparks. Then you can use an air gun to blow them clean. Lower the high-frequency frequency and keep high-frequency products clean. Here I will introduce how to deal with common faults of high-frequency equipment:

The plastic products extruded by high-frequency equipment are not ideal. The solution is:

1. If the high-cycle output is too large or too small, the harmonizer should be adjusted and tested repeatedly to adjust it to a qualified parameter.

2. If the welding time of high-frequency equipment is too long or too short, the welding time should be adjusted accordingly or lengthened according to different materials.

3. The high-frequency electronic tube is aging. You should replace it with a new one and test it. (The following are high frequency tubes with different powers)

4. If the temperature of high-frequency equipment is too low or too high, you should check whether the thermostat and heating tube have been burned out or adjust the temperature accordingly.